Revolution ND-20, Manual

Page: 4 / 27

- 2 -
-Under the influence of alcohol or
drugs.
-While using a cell phone or other
types of electronic devices.
-If not in proper operating condition.
-In outdoor areas. This machine is for
indoor use only.
-In areas where flammable
vapors/liquids or combustible dusts
are present.
-With pads or accessories not
supplied or approved by cwz. The
use of other pads may impair safety.
-In areas with possible falling
objects.
-In areas that are too dark to safely
see the controls or operate machine.
2 ,
Before operating machine:
-Check machine for fluid leaks.
-Make sure all safety devices are in
place and operate properly.
3When operating machine:
-Use only as described in this
manual.
-Report machine damage or faulty
operation immediately.
-Wear closed- toe, non- slip work
shoes.
-Reduce speed when turning.
-Go slowly on inclines and slippery
surfaces.
-Do not scrub on inclines that exceed
9%
-grade or transport on inclines that
exceed 21% grade.
-Follow site safety guidelines
concerning wet floors.
-Follow mixing, handling and
disposal instructions on chemical
containers.
-Do not carry passengers on
machine.
-Use care when reversing machine.
-Keep children and unauthorized
persons away from machine.
-Do not allow machine to be used as
a toy.
4.Before leaving or servicing
machine:
-Stop on level surface.
-Turn off machine and remove key.
5.When servicing machine:
-Disconnect battery connection and
charger cord before working on
machine.
-All work must be done with
sufficient lighting and visibility.
-All repairs must be performed by
trained personnel.
-Use Tennant supplied or approved
replacement parts.
-Do not modify the machine from its
original design.
-Do not jack up machine.
-Avoid moving parts. Do not wear
loose clothing or jewelry and secure
long hair.
-Do not disconnect the off- board
charger’s DC cord from the
machine’s receptacle when the
charger is operating. Arcing may
result. If the charger must be
interrupted during charging cycle,
disconnect the AC power supply
cord first.
-Do not use incompatible battery
chargers as this may damage
battery packs and potentially cause
a fire hazard.
-Inspect charger cord regularly for
damage.
-Keep work area well ventilated.