Revolution 221211, User Manual

Page: 13 / 24

13 13
EN
Assembly of the appliance
• Place the appliance on a flat and stable surface
and ensure it is unplug from the electrical supply.
• Next, place the bowl (3) on the motor base (5) and
ensure the filter (2) is placed inside the bowl (3).
• Pull out the cone (1) and insert the selected cone
(1) that suitable for your purpose along the shaft
(4). Rotate it until insert inside.
• Put the fruit on the surface of the cone (1) and
ready for operation.
Operation
• Make sure the switch is at the “0 (OFF)” position.
Then, connect the power plug to a suitable elec-
trical outlet.
• Place a container (not included) on the stand cov-
er (7) and under the spout.
• Switch on the power switch (6) to the position “I”.
• Align the centre of the fruit with the cone (1) head
and hold it on the “cone (1).
• Repeat above operation and change to another
fruit if no more juice coming out from the spout.
Note: 1. Empty the bowl (3) regularly to avoid over-
flow or jamming.
2. Warning: Kitchen utensils should not be
used under any circumstances to push the
fruit into the appliance. This will damage
to the appliance.
Overheat protection
There is a built-in motor thermal cut-out to protect the motor from overheating.
• When the motor is running very slowly or it stops,
this thermal cut-out activates.
• To reset it, switch OFF the appliance to the “0”
position and unplug it.
• Leave the appliance for cooling down for about
30 minutes.
• Then, the appliance can be used again after
switch ON.
Cleaning and Maintenance
Important! Unplug the power cord from the electrical outlet before cleaning the appliance.
• Remove all accessories from the motor unit.
• Rinse all parts that contact with juice directly af-
ter use.
• Straight after use, hold the cone under warm
flowing water, clean it with a soft brush (not sup-
plied) and then let it dry.
• Clean the bowl, filter (2) with warm water with
some mild soap solution.
• Never immerse the motor unit under water.
Clean and wipe the motor unit and housing with a
slightly damp cloth.
• Store the appliance in a cool, dry place and out of
reach of the children.
• No any accessories/parts are dishwasher safe.
Troubleshooting
If the appliance does not function properly, please check the below table for the solution.
If you are unable to solve the problem, please contact the supplier / service provider.
Problem Possible cause Possible solution
Motor does not run after being
switched ON. The appliance does not plug in properly
with the electrical power outlet Check again the plug to see if it is connected
properly
Motor is running with loud noises
and great vibrations. - The appliance is not well assembled.
- Too many ingredients that clogged in-
side the bowl (3).
- Unplug it and reassemble the appliance cor-
rectly (See → Assembly).
- Unplug it. Clear some food & restart.
Motor slows down & stops. Built-in overheating device activates. - Switch OFF the appliance by pressing the
switch (6) to “0” position and unplug the ap-
pliance.
- Leaving the appliance to cool down for about 30
minutes and start again.