6
Baud rate setting:
Set DIP switches 9 and 10 to set the RS-485 baud rate of the
camera. The baud rate can be set to 2400, 4800, 9600, or 19200
bps. Make sure that the baud rate of the camera matches the
baud rate of the controlling DVR or joystick keyboard.
A switch in the “up” position (“ON”) is set to 1.
A s
witch in the “down” position (“OFF”) is set to 0.
Baud rate DIP switch table:
DIP
Switch
2400 bps
4800 bps
9600 bps
19200 bps
9
0 (Down or OFF)
1 (Up or ON)
0 (Down or OFF)
1 (Up or ON)
10
0 (Down or OFF)
0 (Down or OFF)
1 (Up or ON)
1 (Up or ON)
NOTE: The camera must be powered down and then
powered up to enable any changes made to the DIP
switch settings.
Protocol setting:
No camera settings are needed, as the camera will automatically
detect Pelco-D or Pelco-P protocols. Make sure that the controlling
DVR or joystick keyboard has been set to use only Pelco-D or
Pelco-P as the RS-485 protocol.
If your DVR or joystick keyboard has additional RS-485 settings,
make them match the following:
Data Bit: 8
Stop Bit: 1
Parity: NONE
