REVIER MANAGER RM4eco, User Manual

Page: 28 / 59

28
4. INSERT/REMOVE THE BATTERIES
1. Open the camera by pulling the handle to the side, loosen the clasp and
fold the front part forward on.
2. Push the button under the keys, then the battery slot of the camera can
be pulled downwards.
3.
VARIANT 1:
4, 8 or 12x AA batteries can be inserted, Please note
the + and - polarity of the batteries!
Attention:
Only 1.5V alkaline batteries, size AA, may be used. Other
battery types can have a negative effect on the negatively influence the
functionality.
VARIANT 2:
Alternatively, the Reviermanager game camera can be
externally powered with the Reviermanager battery case. You can find
more information can be found at: www.reviermanager.at
VARIANT 3:
With the new battery compartment with included charging
circuit, you can now also operate the game camera with a 6V solar panel!
In addition, rechargeable batteries are required in the battery
compartment, 12 1.2V NiMH AA rechargeable batteries.
Attention: DO NOT
use alkaline batteries (or other non-rechargeable
batteries)
in combination with the solar panel.
4. Push the battery compartment back into the game camera until it clicks
into place.
Note:
Before removing the batteries, make sure the camera is switched
off (switch to OFF). For the renewed See point 5 „Initial start-up of the
camera“.
Hint:
Check the time in the menu of the camera if the camera has been
without power for a long time. The time can also be set easily via app
when the camera is turned on (switch turned to ON).
Note:
When closing the camera it should be noted that the locking
mechanism isn´t too loose. The rubber seals must be clean and shut
tightly. Clean dirt cautiously. When the seal is damaged it must be replaced
immediately. (Damages caused by moisture that entered the camera due
to damaged seals are not covered by warranty and warranty is void).
English