5
Reverso Pumps, Inc. www.reversopumps.com | [email protected] | Ph: (954) 522-0882
Technical Specifications, Electrical, and Installation
Basic Features
• 12 or 24 Volt
• 2, 3, or 4 Engine setup
• Start button with LED status indicator
• 3’ inlet hose kit included
Optional Features
• Remote Switch Kit with LED status indicator. Available in
lengths of 3, 6, 9, 12, 15 and 18 feet
• Inlet Hose Kit. Available in hose lengths of 1, 2, 3, 6, and
9 feet
Primary Inspection
• Upon delivery inspect the system for any damage that
may have occurred during shipment.
• If the unit is damaged upon delivery, contact the
shipping company immediately.
Mounting
• Mounting holes: Ø 3/16”
• Orientation: Any direction on
a flat surface of the bulkhead
or accessories compartment,
except upsidedown.
Electrical
• Installation must include protection with 5A fuse or
breaker (provided by installer).
• ONLY CONNECT BLACK (-) AND RED (+) WIRES
TO SAME RESPECTIVE COLOR. DAMAGE CAN
OCCUR TO THE SYSTEM IF THE WIRES ARE
CROSSED.
• Installation of unit should only be performed by
qualified electrician who have thoroughly read and
understands the installation instructions covered in
this manual and adhere to ABYC requirements.
• To avoid the risk of harm or injury, make sure that
the power supply is disconnected. Ensure that
the power supply is at zero volts with a multimeter
before making any electrical connections.
• Be sure that the power source available matches
the power requirements.
Connection to Engines
Hose: Smaller than the required diameter hose is
not recommended. Choose fittings which fit the
appropriate hose size. The hose will run from the
system, through the outboard loom, and to the engine.
Locate the flushing port on the engine, split the line,
and connect the hose. Or, choose to install a tee.
Important: Sealed Water Inlet
Incorporate a sealed cap for the water inlet to block
any backflow. Choose one of the following ways:
• Install the Inlet Hose Kit which includes a cap on
the hose end already (shown below).
• If the Inlet Hose Kit is not used, an alternative can
be a bulkhead cap, quick disconnect, or other
sealed fitting provided by the installer.
Technical Specifications
Voltage
12V or 24V
Max. Amp. Draw
3A / 12V
1.5A / 24V
Water Inlet Hose
3/4”
Water Outlet
To Engine
3/8” hose barb, or 1/2” hose barb for
engines over 300HP
Dimensions
2 Engine Setup
A
10.5” / 267 mm
B
10” / 254 mm
C
4.7” / 119 mm
Dimensions
3 Engine Setup
A
14.17” / 360 mm
B
10” / 267 mm
C
4.7” / 119 mm
Dimensions
4 Engine Setup
A
17.84” / 453 mm
B
10” / 267 mm
C
4.7” / 119 mm
Dimensions
5 Engine Setup
A
21.5” / 546 mm
B
10” / 267 mm
C
4.7” / 119 mm
3
/
4
” ID
3
/
8
” ID
1
/
2
” ID
3/8” inner diameter hose is required
for water
outlet
(to engines).
Reinforced hose is recommended.
On the version designed for
engines over 300HP, 1/2” inner
diameter hose is required for water
outlet
(to engines). Reinforced
hose is recommended.
3/4” inner diameter hose is required
for water
inlet
.
Capped fitting on the
Inlet Hose Kit
