MAINTENANCE
This appliance should be serviced regularly, to ensure continuing safety and efficiency
contact a qualified technician at least annually.
For cleaning, turn the gas control knob to the "OFF" position. This will extinguish the pilot
flame. Wait at least five (5) minutes before cleaning.
See previous instructions regarding the trim kits and describing how the door assembly is
fastened.
Remove the glass door carefully and place in a safe corner until ready for reassemble.
Gently remove the embers and place on a piece of paper towel until read)
,
to replace.
Remove the logs carefully from the combustion chamber and vacuum the burner
compartment thoroughly Vacuum any dust on the logs and remove an}' lint from the main
burner and pilot burner.
Make sure the slot below the glass door is free and clear of dust balls or lint as this is where
the appliance draws its air for safe combustion.
Before replacing the logs, relight the pilot following the instructions on the attached label,
and turn on the main burner.
1 Check to ensure that all burner ports are lit and burning properly.
2 Check to ensure that one branch of the pilot flame is engulfing the thermocouple tip and the
other branch is long enough to light the rear main burners.
3 Check to ensure that the main burner lights instantly when the on switch is turned on and
that the flame carries across to the front burner fairly evenly.
When these checks are complete, shut down the burner and pilot, wait a few minutes for the
appliance to cool down, before reinstalling the log set in the precise positions described in
the previous instructions.
Periodically check to ensure that the vent system is clear and that a negative draft is present
when the unit is operating.
17.
