4
TROUBLESHOOTING
TURN OFF ALL GAS KNOBS AND VALVES BEFORE SERVICING THE BARBECUE
Burner does
not light
Barbecue flames
flare up/Excessive
smoke.
Low heat/Low flame
when burner turned
to High.
Check whether burner will light with match. If YES, turn gas to off, ensure
the electrode wire is connected to the ignitor check for spark at electrode.
Bend the tab to adjust the gap If necessary. The gap should be 1/4”. If NO,
check fuel gauge for sufficient gas. Check that valve is on. Check that gas
line has no kinks.
Ensure that the barbecue is being pre-heated prior to each use. Ensure that
the barbecue is cleaned regularly. Check that the sear bars are clean and
installed correctly. Check that the grease tray is clean so that grease can run
into drip pan.
DO NOT LINE ANY INTERIOR COMPONENTS WITH ALUMINUM FOIL.
Natural – Ensure supply valve is in full open position. Pipe must be sized
according to installation code.
Propane – Check whether cylinder is turned on with burner valve(s) in other
than off position. Turn cylinder off; turn burner(s) off. Turn on cylinder.
LIGHTING INSTRUCTIONS
Open Lid
Ensuring burner controls are in
the off position, turn on the gas
supply valve.
Main Burner Lighting
If ignition is not immediate turn the burner
control off. Wait 5 minutes.
Turn the burner control
to high position
Remove the grills to
access the burner
Remove the grills and the
sear bars to access the burner
Push igniter several times or light by
holding a lit match against the burner.
AUTO
MANUAL
MANUAL
Back Burner Lighting
