Press the FLAT button 3 times to
enter Tandem Mode. You will see
a solid green light on the remote to
confirm.
To now control both sides in tandem,
press the FLAT button 3 times. The
remote light will now flash between
red and green.
To change between one side and
tandem control, press the FLAT
button three times, repeat this
to toggle between sides and the
Tandem Feature.
TO CHANGE BETWEEN
ONE SIDE AND TANDEM
CONTROL
STEP 1
STEP 3
STEP 2
TANDEM FEATURE
If you want 2 sides to move in
sync when using one remote
(recommended for Split King/Cal
King units) you can pair to both
sides using the Tandem Feature.
You can also pair two remotes to
two sides, so that either remote can
control both sides at the same time.
You
r
remote should a
l
ready be
paired to one of the control boxes.
Identify which one this is before you
begin. You must pair to the second
control box in order to use the
tandem feature. Repeat this
process if you want 2 remotes
paired to both sides.
Press and hold the pairing button on
the second control box then press
any button on the remote control.
You are now paired to the second
control box. The remote light will still
be green.
NOTE: This power base
may have minor intermittent
performance due to RF
Interference. This is a normal
operation of the power base and
is not a defect.
NOTE: Please remember to
recycle all electronics.
NOTE: This device complies with
part 15 of the fcc rules. Operation
is subject to the following two
conditions: (1) This device may
not cause harmful interference
(2) This device must accept any
interference received, including
interference that may cause
undesired operation.
NOTICE: Changes or
modifications not expressly
approved by the party responsible
for compliance could void the
user’s authority to operate the
equipment.
IMPORTANT NOTE:
To comply with the FCC RF exposure
compliance requirements, no change
to the antenna or the device is
permitted. Any change to the antenna
or the device could result in the
device exceeding the RF exposure
requirements and void user’s authority
to operate the device.
ADDITIONAL REMOTE
FEATURES:
• The buttons are back-lit when
a button is pressed, to aid the
visibility of the remote in low
light environments.
•
Customers can control the
remote without facing the
receiver (best transmission
range is within 30 feet or 10
meters).
•
This Base uses a RF (Radio
Frequency) remote control
system.
•
The included remote is already
paired with your power base,
so should be operational right
out of the box. Please test
some of the features to ensure
functionality.
•
Only replacement remote
controls require pairing
instruction on following pages.
If you find that your remote is
not paired with the bed, please
follow those Bluetooth pairing
instructions.