REVENTON AC100WN1P, Technical Documentation Manual

Page: 5 / 10

3. INSTALLATION
3.1. GENERAL PRINCIPLES
The following figures show minimum distances between the air curtain and the
building partition :
The width of the curtain should be greater or equal to the width of the door frame.
When the entrance is wider than the unit, it is recommended to install two or more
units in parallel. In this case, provide 10-40 mm gaps between the units
3.2. ASSEBLY “STEP BY STEP”
The curtain can be assembled on wall or ceiling. If any components are not included
in the kit, you should buy them yourself and make sure they are suitable
for this type of installation.
a) wall mounting
- unscrew the fixing screws to remove the mounting plate from the back
of the main body
- install mounting plate on the wall
- install the main body. Set the main body onto the upper end of the mounting
plate and clamp it as shown
b) ceiling mounting (using mounting studs)
- screw the mounting studs into four threaded holes (for min 20 mm)
- install the unit using mounting studs to the ceiling
4. INSTALLATION INSTRUCTIONS
4.1. CONNECTION OF THE DEVICE TO THE HYDAULIC SYSTEM
- pipes should be connected like on the figure below (water supply form the front,
water return from the back)
RETURN
SUPPLY
2.3 m