White Wolf Helicopter and Controller Parts
page 3
page 2
White Wolf Helicopter Features:
Counter-rotating
main rotor blades
Tail boom
Tail motor
Landing gear
On/Off power switch
Power indicator light
Controller Features:
Flight Battery Features:
Balance Charger Features:
Transmitter antenna
Transmission
indicator
Throttle stick
Direction stick (left,
right, forward and
backward)
Power switch
Left and right
trim dial
Forward and
backward trim dial
Power indicator
light
Note:
Always allow the fl ight battery to cool down 15 minutes after a fl ight before re-charging the fl ight battery.
1.
Turn off both the White Wolf and the controller.
2.
Disconnect the red plug from the speed control.
3.
Plug the 110V AC Adapter into the wall and connect the 12V DC plug to the
balance charger. The indicator light will turn red, then turn green, and then turn
off during initialization.
4.
If the indicator light on the balance charger fl ashes red at any time during the
charge process, immediately unplug the battery and contact technical support.
If the battery is hot, begins to swell or begins to smoke, then immediately
disconnect the battery from the charger and carefully move the battery to a
fi reproof location!
5.
When the battery is not connected the indicator light will fl ash green once every
fi ve seconds, indicating that the charger is in standby mode.
6.
Carefully plug the balance charging lead (white plug) of the fl ight battery into
the balance charger charging port. DO NOT FORCE. The indicator light on the
balance charger will turn solid green, indicating the battery is charging.
7.
When the indicator light fl ashes green (once per second), charging is complete.
Remove the screw
to release the
battery cover for
battery installation
and removal.
Throttle Down Position
Note:
Before turning
on the controller, the
throttle stick must be
in the down position.
Battery cover
1.
Remove the screw
above the battery
cover by turning it
counter-clockwise
using a Phillips-head
screwdriver.
2.
Install 8 “AA” size
batteries in the battery
compartment following
the polarity shown
inside.
3.
Replace and
tighten the screw
clockwise.
Battery Installation
Charging the White Wolf’s Flight Battery
Flying Your White Wolf
• Slowly move the throttle stick up (or away from you) to raise your White Wolf about 1.5 feet (0.5 meter) to 3 feet (1 meter) high.
1. HOW TO TRIM:
-
-
-
-
-
-
-
-
+
+
+
+
+
+
+
+
The White Wolf can fl y for about 6-8 minutes on a single charge.
Please Note:
The power of your White Wolf’s battery will gradually
increase over the fi rst 4-5 cycles of fl ying and recharging. You can
expect to enjoy its full performance after these initial fl ights.
With the throttle (or left) stick of controller in the down position, move the controller’s power switch to ON. The throttle stick must remain
at this low position when you turn the helicopter on. Then, set the ON/OFF switch of the White Wolf to ON. Place the White Wolf 10 feet
(3 m) away from you on the fl oor with the tail pointing toward you. The White Wolf has a safe start feature that will prevent the main rotor
blades from spinning until you have “armed” the model. To arm the White Wolf, slowly move the throttle to the full position and hold for
one second. Bring the throttle stick back to idle. The helicopter should now be armed. If the White Wolf does not operate please try this
procedure again, making sure the throttle is moved from the full low position to its highest position.
Flashing red light = low battery,
change battery
If the White Wolf spirals to the left or keeps turning left, turn the left and right
trim dial clockwise until the White Wolf no longer spirals.
If the White Wolf constantly moves forward, turn the forward and backward trim dial clockwise until the White Wolf no longer moves forward. If the White Wolf
constantly moves backward, turn the forward and backward trim dial counter-clockwise until the White Wolf no longer moves backward.
If the White Wolf spirals to the right or keeps turning right, turn the left and right
trim dial counter-clockwise until the White Wolf no longer spirals.
Spirals right or
Keeps turning right
Spirals left or
Keeps turning left
Constantly moves forward
Constantly moves backward
The White Wolf is equipped with an in-fl ight safety feature that automatically reduces throttle power when the battery needs to be recharged. The loss
of throttle forces you to land. For the best performance, turn the White Wolf off immediately after landing. Let the battery cool for 15 minutes before
recharging it again. Do not continue fl ying after the throttle power drops — this may damage the battery and permanently reduce fl ight times.
110V AC Adapter
Power/Status Indicator Light
Charging Port
Protective
plastic case
Charging lead (white plug)
Discharging lead (red plug)
10 feet (3 m) away
Pic 1
Pic 2
Pic 3
Pic 6
Pic 4-5
