background image

Piloto and Controller Parts

page 3

page 2

Piloto

Biplane wing

Magnetic actuator 
(for rudder control)

Pusher propeller

On/Off Switch

Charging jack

Controller

Power-on LED (green)

Charge status LED (red)

Throttle stick

Direction stick

Note:

 Before recharging the Piloto’s LiPo battery after fl ying, always wait 10-15 minutes for it to cool down.

1.

  Turn off both the Piloto and the controller.

2.

  Pull out the charge cord from the back of the controller. 

(Pic 1).

3.

  Gently plug the charge cord into the Piloto (Pic. 2). 

DO NOT FORCE. It only inserts one way. When inserted 
properly, the charge cord should fi t easily into the charging 
port. Incorrectly inserting the charge cord will damage the 
Piloto and may create a hazard.

4.

  Push the controller’s power switch to the ON position (Pic. 3). 

5.

  The green Power-on LED and red Charge Status LED will 

both glow (Pic. 4). 

6.

  Charging is complete when the red Charge Status LED 

goes out.

7.

  Push the controller’s power switch to the OFF position and 

remove the charge cord from the Piloto.

Remove the screw 
to release the 
battery cover for 
battery installation 
and removal.

Throttle Down Position

Note:

 Before turning 

on the controller, the 
throttle stick must be 
in the down position.

Battery cover

1.

  Remove the screw 

from the battery 
cover by turning it 
counter-clockwise 
using a Phillips-head 
screwdriver.

2.

  Install 6 “AA” size 

batteries in the battery 
compartment following 
the polarity shown 
inside.

3.

  Replace and 

tighten the screw 
clockwise. 

Pic 1

Controller Battery Installation

Piloto Charging Procedure

Flying Your Piloto

•  An ideal fl ying site is an open, uncluttered room that measures approximately 

20 ft (6 m) wide x 20 ft (6 m) long x 8 feet (2.5 m) high.

1. HOW TO LAUNCH:

Pic 4

Pic 3

The Piloto can fl y for about 3-5 minutes after 10-15 minutes of charging.

Then, set the Piloto’s 
ON/OFF switch to ON.

With the throttle (left) stick in 

the down position, move the 

controller’s power switch to 

the ON position. The green 

Power-on LED will light.

Keep fi ngers, hair, 
clothing and all other 
objects away from the 
spinning propeller.

With the other hand, slowly move the 
controller’s throttle (left) stick from the 
down position to halfway up. 

With one hand, grip the Piloto at the 
bottom of the fuselage

Antenna (pull out 
and extend before 
fl ying — retract 
when not in use for 
safe storage)

Charge cord for Piloto 
battery recharging.

On/off switch

Pic 2

Now gently toss the Piloto into the air, at a slight 
upward angle. The Piloto performs best in still 
conditions. If you detect any air movement, launch 
into the direction air is moving from.

Reviews: