Reveal ZERO ZONE, Installation & Operation Manual, Page: 16 / 25

14 • Installation & Operation
INSTALLATION & OPERATION
Mirrors
Mirror assemblies include the mirrors, brackets, supports, and an air deflector, which are shipped together as a kit.
1. Assemble the support brackets to the mirror support. Slide the tabs on the brackets into the slots in the mirror support. Use the supplied
hex screws to fasten the brackets in place ( See Figure 20 ). Note: There will be 3 brackets and 3 screws for 36" wide mirrors or
4 brackets and 4 screws for 48" wide mirrors.
2. Install the mirror support into the shelf standards, using both the second and third slots from the top ( See Figure 21 ).
FIGURE 20: Support Brackets and Mirror Support
Support
Bracket
Mirror
Support
Add Hex
Screws
FIGURE 21: Install Mirror Support into the Shelf Standards
Install into second
and third slots
from the top
FIGURE 22: Shelf Standard Slots for Air Deflector
MIRROR HEIGHT SLOT FOR AIR DEFLECTOR
8" Tall 6th Slot from Top
12" Tall 9th Slot from Top
20" Tall 16th Slot from Top
24" Tall 19th Slot from Top
FIGURE 23: Install Air Deflector Under Mirror Support
Install into shelf
standards
Air
Deflector
FIGURE 24: Hang the Mirror, Insert Top First
First insert into the top brackets,
then into the bottom brackets
Mirror
3. Install the air deflector (also called a “mirror scoop”) into the shelf standards
under the mirror support. Refer to the table for the correct slot, counting down
from the top ( See Figure 22 and Figure 23 ).
4. peel the protective coating off of the mirror. Hang the mirror from the brackets.
Start by inserting it into the top and then the bottom ( See Figure 24 ).
5. Center the mirror for optimal product display.