2
Customer Service:
800-626-1126 | rev-a-shelf.com
I-RVKDRB-1018
FIG. C
FIG. D
#2
#2
#2
#2
#2
#2
Attach both uprights into the
tubes located on the frame
(See
Figure C)
.
Finally attach the optional handle
and insert the waste container.
Note: Handle should only
be used if you are not using
the optional Rev-a-shelf door
mounting kit (sold separately).
Begin by setting the frame inside
the cabinet. Locate the position
of where you would like it to be
mounted.
Note: Look to make sure that
there is no interference with
the cabinet door when opening
and closing.
STEP 1
With the frame securely in place,
slide the frame out of the cabinet
and remove the (2) pre-installed
screws on the rear of the frame.
The rear basket can be installed
using these (2) screws
(See Figure B)
.
Note: For 16” depth or shorter
applications, the rear basket can
be left off .
STEP 2
With the frame in the closed
position, insert the front (2) #8 x
3/4”screws, making sure that the
frame is square to the front of the
cabinet. Then install the (2) #8 x
3/4”rear screws
(See Figure A)
.
STEP 3
FIG. A
FIG. B
STEP 4
STEP 5
