Safety
14
2.7 Preventing risks during normal operation
Non-compliance with the following safety instructions is contrary to the intended use and
constitutes a danger to personnel and a risk to operational safety.
Transport and set up
•
Do not carry the device alone during transport and set up.
•
Wear protective footwear during transport and set up.
•
The device may only be connected to sockets with PE conductor.
•
When connecting the device, the values on the nameplate must match the values of the
electrical connection.
Operation
•
Read the manual before using the appliance.
•
Only operate the device at a workstation with sufficient space for secure set up of the
device.
•
Check the mains lead for damage before operation.
•
Do not operate the device if damage is visible or suspected.
•
Only operate the device in accordance with technical limits of use.
•
During operation, do not wear jewellery, open hair, a tie or similar loose clothing.
•
Wear eye protection when operating without noise protection funnel.
•
Wear hearing protection when operating without noise protection funnel.
•
Before operating the device, take measures to allow for limited communication while the
device is in operation.
•
Emergency release of the device hood may only be carried out when the grinding gear is
at an absolute standstill.
•
Do not operate the device in potentially explosive atmospheres.
•
Observe safety data sheets of samples and follow the instructions by taking appropriate
measures in advance.
•
Do not grind explosive and/or flammable substances.
•
Do not grind substances that may become explosive and/or flammable during grinding.
•
During operation, components that feed sample material can heat up or cool down
considerably. Before sampling, wait for temperature equalisation and wear protective
gloves if necessary.
•
Pay attention to the surroundings during grinding, as it is difficult to notice acoustic
signals due to the background noise.
•
Emergency release of the device must not be carried out under any circumstances while
the device is in operation.
Maintenance and repair
•
Before maintenance, switch off the device with the main switch.
•
Do not clean the device with running water.
•
Do not clean the device with compressed air.
•
Repairs may only be carried out by the manufacturer of the device or an authorised
representative.
