Display and operation
33
6.6.4 Interval
The interval time can be set here according to the grinding time. If not interval has been set, no
direction reversal can be set.
6.6.5 Direction reversal
On/off
The device is started with the preselected grinding time, speed and direction reversal. The
machine rotates in one direction for the set interval time, comes to a halt, and starts again
immediately in the other direction without a pause time.
6.6.6 Pause time
The pause time between intervals can be set here.
No pause time can be set if no interval has been set.
The device is started with the preselected grinding time, speed, direction reversal and the set
pause time. The machine rotates in one direction for the set interval time and comes to a halt;
once it has stopped at the set interval time, the previously set pause time is displayed and
counts down to 00:00:00.
The device starts again in the other direction when the pause time has expired.
6.6.7 Save parameters
The previously set parameters such as grinding time and speed can be saved in a memory
here.
• Set the desired parameters.
• By turning the operating button (
F
), switch to the Save parameters menu item.
• Press the operating button (
F
).
–
The Save parameters menu opens and the dark line cursor is on Program.
• Press the operating button (
F
) to select a program memory location.
• By pressing the operating button (
F
), switch to the desired memory location.
• Press the operating button (
F
) to exit the memory location selection.
• Select either
–
Save to save settings or
–
Back to cancel without saving.
6.7 Programme Mode
6.7.1 Change program
You can change the saved parameters for any program in this menu.
•
By turning the control knob (
F
), switch to the Change program menu option.
•
Press the control knob (
F
).
–
The Save parameters menu opens and the dark cursor line is on Program.
NOTICE
You can change the active program or any other program.
•
Press the control knob (
F
) to activate the program selection.
•
By turning the control knob (
F
), switch to the desired memory location.
•
Press the control knob (
F
) to exit the memory location selection.
•
Adjust the desired grinding parameters.
•
Finally select either
-
Save to save settings or
-
Back to cancel without saving.
– This takes you back to the Program level.