08
09
To guarantee optimal performance as well as a long service lift
of your radio, please follow the tips below.
- Keep your radio dry. Rain, moisture and liquid or water may
contain mineral substance that can corrode the electronic circuit.
- Take out the battery when the radio is wet, install the battery
pack when it is completely dry.
- Keep away the radio from hot place. High temperature may
cause electrical instrument working life shorten, battery pack
damaged and plastic component deformation or dissolved.
- Do not throw, knock or shock the radio. Use it rudely may damage
internal circuit board and accurate structure.
- Do not use any strong chemicals, cleaner of detergent to clean
the radio.
- Do not paint the radio. Painting may block the demountable
component to influence normal operation.
- Do not hold the radio by its antenna or headset cable directly.
- Use supplied or approved antenna when change antenna.
Unapproved antenna, modified accessories may damage the
radio and violate the relevant rules.
- Attach the accessory jack cover when the radio is not in use.
- Make a back-up copy (like frequencies and channels.) before you
take your radio to service center.
Note :
Every tip above are all applicable for your radio, battery pack,
desktop charger and accessories. Consult your dealer or take your
radio to nearest service center if any parts cannot work normally.
TROUBLESHOOTING GUIDE
CARE AND CLEANING
SOLUTION
No power.
Battery power
dies shortly after
charging.
Cannot talk to or
hear other members
in your group.
Other voices (besid-
es group members)
are present on the
channel.
PROBLEM
The battery pack may be dead.
Recharge or replace the battery pack.
The battery pack may not be installed
correctly. Remove the battery pack
and install it again.
The battery pack life is finished.
Replace the battery pack with a new
one.
Make sure you are using the same
frequency and CTCSS/DCS as the
other members in your group.
Other group members may be too far
away. Make sure you are within range
of the other transceivers.
Change the CTCSS/DCS setting. Be
sure to change the tone on all trans-
ceiver in your group.
