Retevis RB27, User Manual

Page: 12 / 25

6.3 Menu settings
6.3.1 Receiving with Privacy Codes (RXCODE) - MENU 01
You can configure different Receiving Privacy Codes for each channel. The selected Privacy Code may be
different for each channel.
Note: Selecting a Privacy Code of "OFF" will disable the Privacy feature. To communicate between two RB27
radios, all radios in your group must be set to the same channel and Privacy Code selections.
The Receiving Privacy Codes setting steps are as follows:
1> Press [MENU] key to enter the main menu, and press [+UP]/[-DOWN] key to enter the MENU 01.
2> Press [MENU] key again to enter the RXCODE menu;
3> Press [+UP]/[-DOWN] key to select the Privacy Code, and the selection range is OFF / 67.0~754N.
Note: The state of the Privacy Code is off, and the display is OFF. When the display is OFF, press the [+UP] key to
select CTCSS with priority, range 67~254.1Hz (50 groups in total); when the display is OFF, press the [-DOWN]
key to select DCS with priority, range D754I-023N (104 groups in total).
During the selection process, Pressing and holding the [+UP]/[-DOWN] key to quickly search for the sub-tone
code.
4> Press [MENU] key to confirm;
5> Press [PTT] or [A/B] key to exit the menu mode.
6.3.2 Transmitting with Privacy Codes (TXCODE) --- MENU 02
You can configure different transmission Privacy Codes for each channel. The selected Privacy Code may be
different for each channel.
MENU No. Name(Full Name) LCD display Selectable
TOT
- Time-Out-Timer
BCLO
-Busy Channel
Lock-out
RING
-Call Tone Select
VOICE
-Voice Reminding
RESET
-Restore defaults
OFF,30,60…180S
*This feature provides a safety switch that limits
transmission time to a programmed value. This will
promote battery conservation by not allowing you to
make excessively long transmissions, and in the event
of a stuck PTT switch it can prevent interference to
other users as well as battery depletion
OFF ON
*Disables the[PTT] key on a channel that is already in
use. The transceiver will sound a beep tone and will not
transmit if the[PTT] key is pressed when a channel is
already in use.
.OFF- close call tone;
.Select 1-10 process, you can listen to the call tone.
.OFF - turn off voice prompts;
.CHI- voice prompt is Chinese;
.ENG- voice prompts in English.
*Allows audible voice confirmation of a key press.
*Resets the radio to factory defaults.
9
10
11
12
13
9