LCD DISPLAY OF TRANSMITTER
Instruction of LCD (transmitter and receiver)
1- Frequency display:
2- Channel display:
3- RF power output: low power display RF , high power display therefore .
4- AF input: level from left to right, indicate the AF input increasing, AF-means
no signal input.
5- LOCK symbol “ ” indicate that the transmitter has been set to lock function. No
lock symbol “ ” indicate that it is not set to lock function. Under LOCK function,
you should push “SET” key 4 times to LOCK function setting item, then push “ ”
key to unlock, finally push SET key to another item function setting.
6- Battery capacity: the battery capacity is separated to 3 lattices. “ ” Full battery
capacity, “ ” 70% battery capacity, “ ” 30% battery capacity. Low battery, the
red LED shining 3 seconds and then closed the AF, close transmitter after 10
seconds.
7- MUTE: it is MUTE, when channels setting.
8- IR infrared symbol: the IR symbol is indicating and green LED shining 5 seconds if
receive any same frequency from receiver, it means IR function is finished.
9- Green LED, it shine 5 seconds when open the transmitter or enter into setting
function.
10- Red LED (low battery warn): It shine 10 seconds to remind to change new
batteries immediately.
LCD OPERATION
LCD OPERATION (transmitter and receiver)
Step 1: Push SET button once to begin operating frequency selection, then push UP
button to increase required frequency, or push DOWN button to reduce
frequency.
Step 2: Push SET button again to open the RF power selection function, then push
UP button to select HIGH power operation, or push DOWN button to select
LOW power operation.
Step 3: Push SET button again to open the Microphone Gain selection function. It
should normally indicate 60, and is not adjustable.
Step 4: Push SET button again to open the LOCK selection function. Push UP to
select LOCK, or push DOWN to UNLOCK. After being set to LOCK, this
function prevents accidental changes to any other functions. For example,
once LOCK is selected, the frequency channel cannot be changed in Step 1.
Step 5: Push SET button again to open the battery type selection function, then push
UP button to select 1.5V Alkaline Battery operation, or push DOWN button to
select 1.2V Rechargeable Battery operation.
Remarks:
Each time the SET button is pressed, the previous selection values will be saved to
memory. There is a 5 second delay after the Green LED is displayed. If there are no
changes after 5 seconds, the display will revert to the main menu without any changes
being recorded.
Step 1 Step 2 Step 3 Step 4 Step 5
3
4
