17. Connect 48 sets of crystal links kit (L) for the third tier. Hang the
crystal links kit around the third tier.
18. Connect 32 sets of crystal links kit (L) for the fourth tier. Hang the
crystal links kit around the fourth tier.
19. Connect 16 sets of crystal links kit (L) for the fifth tier. Hang the
crystal links kit around the fifth tier.
20. Insert the recommended bulbs into sockets.
21. Assembly is complete.
IMPORTANT PLEASE READ
Page 3 of 3
1. Determine the desired placement on the wall for the
cabinet (mounts with hinge at the very left hand).
Within the desired mounting location, locate the studs
and mark using a pencil
2. Determine which wall mount bracket hole or holes will
be centered on a stud. The hole positions that are
centered over the studs will be used to mount.
3. Remove the 2 center rivets on the top and bottom of
Cabinet to expose mounting holes. As shown in
diagram.
4. Holding the cabinet in your desired location, using a
pencil, mark the mounting screw locations on the wall.
5. Remove the cabinet and using a #2 drill bit, drill holes
in the four mounting hole locations. Insert the toggle
anchor slightly into holes.
6. Carefully position cabinet over anchors on the wall,
ensuring that the four mounting holes are aligned.
Insert the Toggle Screws through the mounting holes
and thread into the anchors.
7. Tighten the Toggle Screws (1) with #2 Phillips
screwdriver until the cabinet is flush with the wall.
8. Installation is complete.
SAFETY INSTRUCTIONS:
CARE INSTRUCTIONS:
ASSEMBLY & INSTALLATION:
1. Dust with a clean, soft damp cloth and wipe dry
immediately.
2. Avoid the use of chemicals and harsh cleaning agents.
1. The hardware supplied is intended for dry wall/
stud mounting only.
2. If walls are concrete, brick, or plaster please
consult your local hardware store for assistance.
3. For safety and ease of mounting, installation is
recommended using two people.
R O Y A L N A V A L P O R T H O L E M I R R O R E D M E D I C I N E C A B I N E T
