Restoration Hardware 101607, Assembly Instructions Manual

Page: 13 / 13

Page 13 of 13
Twin Bed Assembly Instruction:
1.Attach the side rails (C) to the tall end(headboard) (A) & short end (footboard) (B) using thread
rods(H),curved slotted washers(I) and wrench(J) that is provided(Refer to Section "A").Place
thread rods in the holes on the tall & short bed post . Align the side rails with the holes and
fasten tightly with curved slotted washers using the wrench provided.
J J
H H
II
A A
C C
C C
D D
B B
Q Q
Side Rail Side Rail
Section "A" Section "A"
T
all End Post
T
all End Post
Section "B" Section "B"
O O
Sect
o
"
i n
B"
Sect
o
"
i n
B"
c
A
Se
tion "
"
c
A
Se
tion "
"
Slat Slat
Q Q
Philip Screwdriver Philip Screwdriver
J J
H H
II
A A
C C
C C
D D
B B
Q Q
Side Rail Side Rail
Section "A" Section "A"
T
all End Post
T
all End Post
Section "B" Section "B"
O O
Sect
on "B"
i
Sect
on "B"
i
Sec
on "A
ti
"
Sec
on "A
ti
"
Slat Slat
Q Q
Philip Screwdriver Philip Screwdriver
2.Lay the slat roll (D) in between the side rails (C) and use slat roll screws #8x1 1/4" (O) to
fasten two end slats to side rails with a screwdriver (Refer to Section "B").
3.Put the wooden caps (Q) on the tall end (headboard).
Bunk bed can convert to two twin beds, assemble beds following below instructions: