1
Shed Alarm
User Manual
INTRODUCTION
The Response Shed Alarm is an intruder alarm and chime integrated system, designed to
protect your shed. It is a simple to use, easy to install unit.
Whats included in the pack :
What you need to purchase :
1 x Shed Alarm
1 x 9V PP3 Alkaline Battery
1 x Door/Window Contact Detector fitted with 5m cable
Fixing Kit (cable clips, screws and wall plugs)
IMPORTANT – Please read this manual carefully, in full, before commencing installation. You
will find installation easier if you follow these steps in the sequence shown.
SAFETY
Before proceeding with the installation, please note the following safety warnings:
DO NOT connect the mains supply directly to the products, this will cause permanent damage
to the products.
Control panel and Door/Window contact are for indoor use only. Avoid mounting location which can
expose the product to splashing or dripping liquid.
Always follow the manufacturer’s advice when using power tools and wear suitable protective
equipment (e.g. safety goggles) when drilling holes, etc. Before drilling holes in walls, check for
hidden electricity cables and water pipes. The use of a cable/pipe locator is advisable if in doubt.
Batteries should not be exposed to excessive heat such as sunshine, fire or the like; danger of
damage if battery is incorrectly replaced. Replace only with the same or equivalent type. (Do not
mix batteries type).
1.
Installation -------------P. 2-3
2.
Working modes --------- P. 4-5
Door chime
Instant alarm
Delay alarm
3.
Panic alarm -------------P.6
4.
Change password -------P.6
5.
Alarm Hold -------------P.6
6.
Indications
-------------P.7
2
1.
Installation
1.1) Mounting of back-plate
a.
Mark holes on the wall near the door with the back-plate.
b.
Then use the screws provided to hang on the back-plate.
1.2) Installation of Main Unit
a.
Make sure the Slide Switch is on
OFF
position.
b.
Install the 9V battery into the battery compartment of the main unit
.
c.
Secure the Main Unit top case / PCB
onto the back-plate.
Mounting
Holes
