II. Installing a Door/Window Sensor
Please refer to the System’s full instruction
manual for detailed programming.
1. Press the Arm Button on the Remote Control
2. The Control Panel will emit one beep to
indicate that it is armed.
3. If your Control Panel is set to delay it will
beep every two seconds for half of the
duration of the delay, it will intensify in
tempo for the remaining duration to warn
that System Arming is imminent.
IV. Remote Control Operation
1. Remove the activation strip from the battery
compartment.
2. Remove the backing paper from one side of each
double-sided adhesive strips. Fix one adhesive
strip to the back of the Magnet and one to the
back of the Transmitter (alternatively for
permanent fixing use the screws supplied).
3. Peel off the other side of each adhesive strip.
Mount the Magnet on the door and the
Transmitter on the door frame (small triangles
facing each other), with less than a 6mm
separation between the two.
4. When opening the door a small red indicator
lights up briefly, this indicates that the
Transmitter has sent a signal to the Control
Panel.
LED
LED
1. Remove the activation strip. Fit the retaining screw
supplied.
2. Self-testing will commence for 1 minute, indicated
by the LED flashing every two seconds. Press the
Test Button, the LED will then flash once when
movement is detected, for up to 3 minutes.
3. Fit the Sensor in a position that will cover your
desired protection area:
a. Fix the bracket to the wall with the fixings kit
supplied. For optimum performance set the
the height of the bracket to 2 metres above
ground level.
b. Adjust angle of the PIR sensor to cover the
required detection area (see diagrams **).
4. To test, walk in front of the Sensor - the LED should
illuminate once when movement is detected. If the
Sensor is triggered twice in 3 minutes, it will enter
into power saving (sleep mode). If no movement is
detected within the next 3 minutes, the Sensor will
return to normal working mode.
III. Installing a PIR Motion Sensor
Top view
Side
2m
Ground
