INSTALLATION INSTRUCTIONS
SeaBat 7125 SV2 Operator‟s Manual
Page 154
July 25, 2011
Version 3
C.3.3 Transceiver Cable Connections
All dry-end cables provided by RESON come with factory-installed connectors to be
attached at the appropriate port(s) on the rear panel of the transceiver.
CAUTION
Do not disconnect any cables from the rear of the transceiver while the unit is running.
This can damage the internal workings of the unit.
The critical connections are clearly marked on the transceiver and shown in
(1)
Power input and switch
(2)
Monitor output (4x display)
(3)
Monitor output (2x DVI)
(4)
Mouse
(5)
Keyboard
(6)
USB (x4)
(7)
Ethernet (x2)
(8)
Trigger in
(9)
1PPS input
(10) Trigger out
(11) Time marker serial port UTC/ZDA
(12) Serial ports with LED indication (x5)
(13) Motion sensor serial port
(14) Alternate SVP serial port
(15) Receiver connection
(16) Projector connection
(17) Main SVP serial port with power
(19) DO NOT USE (for debug only)
(20) Protective earth screw for equipotential
connection
Figure 60: Transceiver Cable Connections
WARNING!
For safety reasons the SeaBat™ must be connected to protective earth. The protective
earth pin in the mains appliance inlet is the protective conductor terminal of SeaBat™.
Summary of Contents for SeaBat 7125 SV2
Page 2: ...This page intentionally left blank...
Page 211: ......
