Reson SeaBat 7125 ROV, Operator'S Manual

Page: 153 / 200

INSTALLATION INSTRUCTIONS
SeaBat 7125 ROV Operator‟s Manual
Page 137 May 30, 2011
Version 3
CAUTION
Do not disconnect any cables from the rear of the processor while the unit is running.
This can damage the internal workings of the unit.
The critical connections are clearly marked on the processor and shown in
Figure 51 .
(1) Power input and switch
(2) Monitor output (4x display)
(3) Monitor output (2x DVI)
(4) Mouse
(5) Keyboard
(6) USB (x4)
(7) Ethernet (x2)
(8) Trigger in
(9) 1PPS input
(10) Trigger out
(11) Time marker serial port UTC/ZDA
(12) Serial ports with LED indication (x5)
(13) Motion sensor serial port
(14) Alternate SVP serial port
(15) Host cable
(16) Main SVP serial port with power
(17) Diagnostic LEDs (see Figure 52 )
(18) Protective earth screw for
equipotential connection
Figure 51: 7125 Processor Cable Connections
WARNING!
For safety r
easons the SeaBat™ must be connected to protective earth. The protective
earth pin in the mains appliance inlet is the protective conductor terminal of SeaBat™.