ADVANCED OPERATIONS
.
17
Changing batteries
The battery in all wireless devices in the alarm system, with the exception of the panel
battery, needs to be changed on a regular basis.
Caution: Except for the GKP keypad and the TCC keyfob, batteries should only
be changed by an approved installer.
Agree a battery change regime with your installer.
Changing the batteries in the GKP keypad
A blinking battery indicator light informs you that the GKP keypad battery needs to be
replaced.
WARNING: THERE IS A RISK OF EXPLOSION IF INCORRECT BATTERIES ARE
USED. REPLACE ONLY WITH A BATTERY OF THE SAME OR AN EQUIVALENT
TYPE RECOMMENDED BY THE MANUFACTURER.
Note:
Dispose of batteries in accordance with the regulations in force in your area.
To change the battery on the GKP keypad:
1. Remove the keypad from the bracket with a
suitable tool.
2. Remove the batteries and replace them with
the new batteries.
3. Install the keypad on its bracket.
Changing the batteries in the TCC keyfob
WARNING: THERE IS A RISK OF EXPLOSION IF THE CORRECT BATTERY IS NOT
USED. REPLACE ONLY WITH BATTERY TYPE CR2032 (PANASONIC OR GP).
When the battery starts to run down, the LEDs will start to fade gradually.
TCC keyfob
1. To change the battery, remove the TCC keyfob from its base (if
present) and unscrew the battery compartment with a screwdriver.
2. Use the screwdriver to push the old battery gently out of its housing.
3. Do not touch any button while inserting the new battery.
4. Align battery cover and attach with the screw.
Note: the operation of changing the batteries of keypads and keyfobs must be completed
in less than 2 minutes to avoid sending a tamper signal to the central monitoring station.
2x CR123
