Figure 3
Figure 4
Figure 5
TO THE INSTALLER
Regular maintenance and inspection (at least annually) by
the installer and frequent testing by the user are vital to
continuous satisfactory operation of any alarm system.
The installer should assume the responsibility of developing
and offering a regular maintenance program to the user, as well
as acquainting the user with the proper operation and
limitations of the alarm system and its component parts.
Recommendations must be included for a specific program of
frequent testing (at least weekly) to ensure the system's
operation at all times.
WARRANTY INFORMATION
For the latest warranty information, please go to:
www.resideo.com
SPECIFICATIONS
Physical
Physical
Physical
Physical
2"W x 3-1/2"H x 1/4"D
(51mm x 89mm x 32mm)
Electrical
Electrical
Electrical
Electrical
Multiplex Supply
1.0mA, MAX Current::::
Operating
Operating
Operating
Operating
32°F to 122°F
Temperature:
Temperature:
Temperature:
Temperature:
0°C to 50°C
Agency:
Agency:
Agency:
Agency:
UL 636 – Holdup alarm units and
systems
Reset
Reset
Reset
Reset Key:
Key:
Key:
Key:
Supplied, Part Number K4563 to
order separately
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
© 2020 Resideo Technologies, Inc.
www.resideo.com
K0400V1D 4/03 Rev D
ROUTE THE WIRE THROUGH THE WIRE ENTRY HOLE.
STRIP 6MM (.24 INCH) OFF THE WIRE ENDS.
269SN-004-V0
TERM. ASSIGNMENT
269SN-002-V0
POLLING LOOP
TERMINALS ON
CONTROL
1 (+) POLLING LOOP (+)
2 ( ) POLLING LOOP ( )
POLLING LOOP
ALWAYS OBSERVE POLARITY.
ALWAYS CONNECT IN PARALLEL.
MOUNTING
SCREW (2)
No. 6X1 3/4
(SUPPLIED)
269SN-009-V1
MOUNTING
HOLE
MOUNTING
HOLE
IMPORTANT:
THIS DEVICE MUST
BE PERMANENTLY
MOUNTED WITH THE
SCREWS SUPPLIED
HOLDUP SWITCH SHOWN MOUNTED
IN TYPICAL UNDER COUNTER APPLICATION
C
US
US
R
LISTED
