Residentia RU9EEB, User Manual, Page: 10 / 52

Electrical connection
• This appliance must be earthed by law. Before connecting the appliance to the
electrical supply, check that the earth system in your house is working correctly.
• Check that unit voltage and power, marked on the rating plate applied on the
appliance, are correct for the supply. It is necessary that the feeding network is
protected by a powerful switch able to disconnect completely the network with a
contacts separation of at least 3 mm. Be sure that the earth wire green/yellow is
not interrupted by the switch.
WARNING: THIS APPLIANCE MUST BE EARTHED
• In order to avoid hazard, any electrical work performed on this equipment or its
associated wiring should only be done by persons authorised by the manifacture
or similary qualified persons.
Replacement or mounting of the power cord
The mains cable is replaced via the rear backboard.
The mains cable must be of the following type:
380-
H05
H05V
H05
H07
-415V 3N~
RR-F
VV-F 5
×
2
RN-F
RN-F
2.5mm2
220-240V
H05RR-F
H05VV-F
H05RN-F
H07RN-F
3
×
4mm2
10
• Connect the yellow-green wire to the t erminal. This wire must be at least 10 mm
longer than the other wires.
• Connect the blue neutral wire to terminal N.
• Connect the brown power wire to terminal L.
Leave the mains cable slightly overlong so that you can pull out the appliance for
cleaning purposes.
Proceed as follows:
• Remove the rear backboard.
• Undo the screw on the terminal block that fixes the cable in place.
• Loosen the screw contacts and replace the cable with a new one of the same length.
The cable must comply with the stipulated specifi- cations.
11