07
UNPACKING
•
Packaging materials
: This wine cellar has been packaged to protect it against transportation
damage. Remove all packaging materials from around and inside the wine cellar and keep
the original packaging carton and materials in a safe place. It will help prevent any damage if
the product needs to be transported in the future, and you can use it to store the wine cellar
when it is not in use. In the event the carton is to be disposed of, please recycle all packaging
materials where possible.
•
Suff ocation:
Plastic wrapping can be a suff ocation hazard for babies and young children, so
ensure all packaging materials are out of their reach and disposed of safely.
•
Power cord:
Unwind the power cord to its full length and inspect it for damage. Do not use
the wine cellar if it or its cord have been damaged or are not working properly. In case of
damage, contact our after sales support line for advice on examination, repair or return of the
damaged product.
•
Read the manual:
Read this manual to familiarise yourself with the wine cellar. Pay particular
attention to the safety instructions on the previous pages.
•
Clean:
To remove any dust from transit and storage, clean the interior and exterior surfaces
of the wine cellar with lukewarm water and a soft cloth. Dry thoroughly.
•
Two person installation:
Use two or more suitably qualifi ed people to move and install the
wine cellar. Failure to do so can result in back or other injury.
•
Freestanding design:
This wine cellar is designed to be freestanding only, and should not be
recessed or built-in.
•
Floor surface:
This wine cellar must be properly positioned on a dry, sturdy, level surface that
is strong enough to support it when it is fully loaded.
Do NOT install/use the wine cellar in the following locations/situations:
• In a garage or any other outside installation.
• In moist areas or areas of high humidity.
• In a recreational vehicle, or for use with an inverter.
• In direct sunlight, near heat sources, next to an open fl ame, cooking or heating appliance, or
near any other source of high heat.
• Direct sunlight may aff ect the acrylic coating and heat sources may increase the unit’s power
consumption. For best energy effi
ciency install the wine cellar in the coolest area of the room.
• In an area with extreme cold ambient temperatures.
• In an area with excessive moisture and high humidity. Make sure it is protected from elements
such as wind, rain, water spray or drips.
• In an area where petrol or other explosive and/or fl ammable liquids or fumes are used or
stored. The fumes can create a fi re hazard or explosion.
•
Levelling:
It is important for the wine cellar to be level in order to work properly. To level the
unit, adjust the levelling legs at the bottom of the wine cellar.
•
Ventilation:
To allow for proper air ventilation, leave a minimum 5cm of space between the
back, sides and top of the wine cellar and make sure that the front of the unit is completely
unobstructed. Ensure that the ventilation openings are never blocked or covered. Never cover
shelves with aluminium foil or any other material, which may prevent air circulation.
•
Door swing:
The door on this appliance can be opened from either the left or the right side.
Should you wish to change the door swing direction, follow the instructions on pages 16–17.
Getting Started
Installation