White pins are used as shown to prevent tubs
from accidentally moving forward.(Fig.19)
Stacking bars are used as shown when
stacking racks. (Fig. 20)
5. Slide a shelf panel into bottom slot. Make
sure that it slides fully into the slots in the back
panel. The front of the shelf should be flush
with the front edge of the side panels. (Fig, 16)
Pull the shelf forward slightly if needed.
Install a screw through each predrilled hole in
sides A and B, being careful not to over tighten
and you are ready to install the next shelf.
6. At this point you can continue assembly
with the rack on it's back, installing each shelf
the same as the first. Install the top by sliding
into place and fastening with screws, the same
as the shelves. Then stand it upright (Fig. 17)
and install screws into the back of the rack.
.
8.Probe placement: Pass the thermostat probe
through the hole in the back panel and using
the aluminum tape affix as shown.(Fig.18)
