Reptile Basics, Inc
CS-8759 6qt Shoebox Rack
Assembly Instructions
Order tubs from
:
Model # 8759
Parts List:
1. Back - Marked "B” On one side and “A" on
the other. Heat tape is installed.
2. Right Side - Marked "A Top"
3. Left Side - Marked "B Top"
4. Top Shelf- no holes for locking pins.
4. 8pcs Shelves- These have holes for locking
pins.
5. Stacking Bar (Used To Stack Racks)
6. Screw
7. White Locking Pins
8. Aluminum Tape
1. Identify the parts listed above and lay them
out. Set the Top Panel aside. It will be the last
piece to be installed.
2. Locate the back panel (A Top B) (1) and the
Right panel (A Top)(2) and align using arrows
and alignment tabs and slots. (Fig. 11&12)
Note that the Text will be on the inside of the
rack and not visible once assembly is
complete. Make sure each tab is fully aligned
in the Slot, then drive screws in through the
pre drilled holes.( Fig. 13,14) *Do Not Over
Tighten* Screw Head should be flush with
outer surface when fully tightened. It will be
self Recessing.
3. Locate the Left panel (B Top)(3) and align
again using arrows and Tab/Slot. Secure with
screws. (Fig. 15)
