RepsGlobal RAP-410, User Manual, Page: 13 / 35

Troubleshooting
P12
Please check the possible correspoding errors (table below), before sending
Fault
Check the items
The machine does not work
During automatic operation,
air quality indicator shows
red or pm2.5 data
It is difficult to get
rid of the odor
It is difficult to clear
the dirt, and works with
Indoor air is polluted,
but the machine does not
work at its highest speed
or the indicator light
The power cord plug is disconnected
from the power outlet:
Reset the power cord plug
The front panel is covered:
Re-cover the front panel,
The host is sloped:
Place flat.
Air quality sensors may be exposed to water vapor,
fumes and sprays:
Move the machine to another clean environment
and test again.
Remove the sensor cover and wipe the sensor lens
with a clean soft cloth.
Check the filters for failure or release of pollutants
due to adsorption.
Clean the activated carbon filter, for example,
after drying.
If there is no improvement, please replace the filter
Check if the chitin HEPA filter is working
Clean the pre-primary filter. If the situation
does not improve, replace the filters
Machine is not placed at a suitable place so
it is difficult to remove the pollution.
Move the machine to a suitable place.
Set the speed at the highest mode, manually.
the faulty machine for repair.
is increasing
unusual noise
does not show red.
13