Repotec RP-G1416Q Manual Download Page 1

1

 

FCC Certifications 

This Equipment has been tested and found to comply with the 
limits  for  a  Class  A  digital  device,  pursuant  to  part  15  of  the 
FCC Rules. These limits  are designed to provide  reasonable 
protection against harmful interference when the equipment is 
operated  in  a  commercial  environment.  This  equipment 
generates, uses, and can radiate radio frequency energy and, 
if  not  installed  and  used  in  accordance  with  the  instruction 
manual, 

may 

cause 

harmful 

interference 

to 

radio 

communications. 

Operation  of  this  equipment  in  a  residential  area  is  likely  to 
cause  harmful  interference  in  which  case  the  user  will  be 
required to correct the interference at his own expense. 

This  device  complies  with  Part  15  of  the  FCC  Rules. 
Operation  is  subject  to  the  following  two  conditions:  (1)  this 
device  may  not  cause  harmful  interference,  and  (2)  this 
device  must  accept  any  interference  received;  including 
interference that may cause undesired operation. 

CE Mark Warning 

This equipment complies with the requirements relating to the 
EMC Directive 2004/108/EC, the Low Voltage Directive 
2006/95/EC, and the RoHS Directive 2011/65/EU.   
 
Company has an on-going policy of upgrading its products 
and it may be possible that information in this document is not 
up-to-date. Please check with your local distributors for the 
latest information. No part of this document can be copied or 
reproduced in any form without written consent from the 
company. 
 
Trademarks: 
All  trade  names  and  trademarks  are  the  properties  of  their 
respective companies. 

Copyright ©  2015, All Rights Reserved. 

Summary of Contents for RP-G1416Q









Reviews: