10
Transformer Instructions
Diagram 1
Diagram 2
Your chair will have been delivered with a transformer
as seen in diagram 1. This transformer is connected to
the power supply and powers the chair.
It should always be kept
flat on the floor and the
right way up
unless you have purchased the wall
mounted version. It has a green LED light which if
illuminated means that it is plugged in and working.
A = Transformer
B = Removable battery case cover
C = 9v battery
D = Battery clip
If your transformer has 9 volt (9v) batteries they are there to enable you to move the chair back
into a seated position if there is a power cut. These batteries:
•
Can only be used once.
•
Will go flat over time even if not used.
•
Cannot be relied upon to reset the chair to a seated position if you are in the chair.
NEVER RELY ON THE BATTERIES TO GET YOU OUT OF THE CHAIR.
You must
always be physically capable of exiting the chair without the use of the batteries. Once out of the
chair reset or add new batteries to do so.
If you are in an area with frequent or long power cuts and would struggle to get out of the chair in
such circumstances, then we would recommend you consider an Accupak battery system.
To change the 9v batteries:
1) Remove the battery case cover (B)
on the Transformer (A).
2) Remove the battery clips (D) from the
batteries (C).
3) Replace batteries and refit clips and
cover - it should be ready for use.