3
Introduction
Congratulations on your purchase of a Renkus-Heinz DC Series or ICC
Digitally Steerable Loudspeaker. Your Renkus-Heinz loudspeaker has been
designed to provide years of trouble-free, high performance operation. We
hope you enjoy it.
Your Renkus-Heinz loudspeaker was completely tested and inspected
before leaving our factory and should have arrived in perfect condition.
Please carefully inspect your loudspeaker and its shipping carton for any
noticeable damage, and if any damage is found, immediately notify the
shipping company.
Important:
Your Renkus-Heinz loudspeaker and its built-in amplifier contain no
user-serviceable parts and all service should be referred to qualified
service personnel. We recommend that it be returned to the factory in
its original packing carton if factory service is required.
General Information
This manual provides guidance on installing your DC or ICC loudspeaker.
Renkus-Heinz loudspeakers are intended for professional installation by
qualified and experienced personell. For details on using or programing
your loudspeaker see the relevant user’s guide.
Wall Mounting
• As the installer you must insure that the wall or other mounting surface
is capable of safely supporting the weight of the array plus a safety
margin. Use mounting hardware and methods suficient to support:
DC12/2: 60 lbs./27. kgs.
ICC12/3: 90 lbs./40.8 kgs.
ICC24/3: 180 lbs./81.6 kgs.
• Dissassemble the bracket into the wall and loudspeaker halves by
removing the 12 mm bolts and star washers.
• Determine the desired mounting location on the wall. The bracket is
centered on the loudspeaker, the center hole of the wall bracket is a
good reference point.
• Mount the wall half of the bracket to the wall using fasteners
appropriate to the structure; for example, 1/4 inch or 6 mm lag bolts into
wooden studs or similarly sized concrete anchors for masonry walls.
• DC12/2 and ICC12/3 arrays are too heavy to be supported by gypsum
wallboard alone, you must anchor the brackets to structure able to
support the weights listed above.
• Remove the three, 6 mm Phillips-head screws from the back of the
loudspeaker using a #3 Phillips screwdriver. Be sure to use a #3
Phillips, using a #2 may damage the screws.
• Mount the loudspeaker half of the bracket to the loudspeaker cabinet
using the three 6 mm Phillips screws. Use thread locking compound to
prevent the screws from loosening.
• Slide the loudspeaker and it’s bracket half over the wall bracket and
secure with the 12 mm bolts and star washers.
• Select the horizontal aiming and tighten the bolts securely to lock the
aiming angle in place.
• Connect the audio and power cables and your loudspeaker is ready to
program and enjoy.
Remove
screws
Reinstall with
same screws
