33
8. Installation/Setup
When selecting the set-up or mounting location, please take into consideration the room layout such as the
whereabouts of the nearest socket, etc.
When selecting the set-up or installation site, observe that direct sunlight, vibration, dust, heat, cold and moisture must
be avoided. There also must not be any strong transformers in the device's proximity.
Do not drill or screw additional screws into the casing in order to fasten the device. It would damage the
product.
Make sure you position or install the device safely. Falling devices may pose a significant risk of accident.
Due to the diversity of furniture paints and polishes used, it is possible that the device's feet will leave
visible residue on furniture due to chemical reaction. The device therefore should not be placed on valuable
furniture surfaces without any suitable protection.
•
If you want to set up your device, put it onto a level, straight surface that can bear the device's load with its housing
feet.
•
For installation under a cabinet or board, screw the enclosed mounting holder to the desired mounting location. The
label UP/FRONT must point upwards and to the front (the holding tabs must point towards the front of the device).
•
Use the enclosed screws or other screws suitable for the mounting surface for mounting.
Summary of Contents for RF-IR-Kitchen1
Page 102: ...102 ...
Page 103: ...103 ...
