
31
Connecting the loudspeaker outputs
The line towards the loudspeakers must be a bifilar cable. Insulate all connecting terminals.
Make sure that there are no sharp edges which could damage the cables. Only use loudspeakers
which have a sufficiently high loading capacity (see „Technical Data“).
Connect the loudspeakers directly with the amplifier.
Do not use headphone adapters or distribution boxes. If you are unsure about anything, please
contact a specialist.
Make sure that all loudspeakers have the correct polarity, i.e. the plus and minus signs must
match.
This amplifier has been built for a loudspeaker impedance from 4 to 8 ohm. Only connect one
loudspeaker to each output.
If you connect loudspeakers to the surround outputs (12) of the amplifier, the minimum
impedance of the loudspeakers connected to the SPEAKER clamps (13) is
8 Ohm each.
• To open the loudspeaker clamps, press the red/black plastic surface. Slide the stripped end of the loudspeaker
cable into the aperture and release the plastic surface. The loudspeaker cable is clamped and good contact is
guaranteed.
Connect the loudspeakers to the clamps marked with SPEAKER (13).
• Connect the (+) pole of the left loudspeaker with the red speaker clamps marked with „L+“.
• Connect the (-) pole of the left loudspeaker with the black speaker clamp marked with „L-“.
• Connect the (+) pole of the right loudspeaker with the red speaker clamps marked with „R+“.
• Connect the (-) pole of the right loudspeaker with the black speaker clamp marked with „R-“.