Renfert 14610000, Instruction Manual

Page: 14 / 82

- 4 - EN
9. Technical data
Maximum power: 23 W (+/- 10 %)
Minimum operating
temperature: 60 °C [140 °F]
Maximum operating
temperature: 110 °C [230 °F]
Power Supply: 230 V / 50 - 60 Hz
100 - 120 V / 50 - 60 Hz
Safety Appliances:
Fuse (not changeable)
rating: 230 V = T 500 mA / 250 V
100 - 120 V = T 250 mA / 250 V
Dimensions
(W x H x D): 90 x 65 x 98 mm
[3.54 x 2.56 x 3.86 inch]
Weight, approx.: 400 g [14.1 oz]
10. Scope of Delivery
1 hotty LED Wax dipping unit
1 Operating Instructions
11. Accessories
GEO-Dip Dipping Wax (elastic):
No. 482-3000 GEO-Dip yellow, 200 g
No. 482-3200 GEO-Dip orange, 200 g
No. 482-3300 GEO-Dip green, 200 g
Rewax Dipping Wax (hard, non-elastic):
No. 651-0000 Rewax yellow, 210 g
12. Troubleshooting
Error Possible cause Corrective action
No display / no op‑
eration, although the
unit is switched on
the main switch (A).
• Power supply interrupted.
• Faulty overheat fuse.
• Faulty unit fuse.
• Check the power supply
and power cords.
• Have fuse replaced by
Service Department.
• Have fuse replaced by
Service Department.
The unit is operat‑
ing but there is no
increase in temper‑
ature.
• Faulty thermal sensor.
• Faulty heater.
• Have probe replaced by
Service Department.
• Have heater repaired by
Service Department.
Temperature has
been changed but is
not saved.
• Mains supply interrupted be-
fore saving values (5 seconds
after changing values).
• Change again tempera-
ture and turn off unit only
after 5 seconds.