Due to continuing product development, specifications are subject to change without notice
EV130_200_300Man_Mar13.docx
134777_012
Revised 03/2013
2013 RenewAire LLC
Page 1
4510 Helgesen Drive, Madison, WI, 53718
608.221.4499, 800.627.4499, Fax: 608.221.2824
[email protected] www.renewaire.com
I
NSTALLATION AND
O
PERATION
M
ANUAL
M
ODEL
EV130\EV200\EV300
E
NERGY
R
ECOVERY
V
ENTILATOR
(ERV)
WARNING
R
ISK OF
F
IRE
,
E
LECTRIC
S
HOCK
,
OR
I
NJURY
.
OBSERVE ALL CODES AND THE FOLLOWING
:
1.
Before servicing or cleaning the unit, unplug the unit line
cord. Make sure unit is not running before opening its
door.
2.
This installation manual shows the suggested installation
method. Additional measures may be required by local
codes and standards.
3.
Installation work and electrical wiring must be done by
qualified professional(s) in accordance with all applicable
codes, standards and licensing requirements.
4.
Any structural alterations necessary for installation must
comply with all applicable building, health, and safety
code requirements.
5.
Connect this unit only to a 120VAC grounded receptacle
protected by a 15 or 20 amp circuit breaker. Do not
remove the unit’s line cord.
6.
Do not install unit or controls where they can be reached
from a tub or shower.
7.
This unit must be properly ducted to the outdoors.
8.
Outside air inlet for this unit must be located away from
sources of hazardous air such as auto exhausts.
9.
Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment that might be installed in the area
affected by this equipment. If this unit is exhausting air
from a space in which chimney-vented fuel burning
equipment is located, take steps to assure that combustion
air supply is not affected. Follow the heating equipment
manufacturer’s requirements and the combustion air
supply requirements of applicable codes and standards.
10.
This unit is intended for general ventilating only. Do not
use to exhaust hazardous or explosive materials and
vapors. Do not connect this unit to range hoods, fume
hoods or collection systems for toxics.
11.
When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
12.
Use the unit only in the manner intended by the
manufacturer. If you have questions, contact the
manufacturer.
CAUTION
1.
To avoid motor bearing damage and noisy and/or
unbalanced impellers, keep drywall spray, construction
dust, etc., out of the unit.
2.
Do not connect power to the units external control
terminals: this will damage the unit. The external
terminals are for use only with un-powered controls
designed for low-voltage operation.
EV130 (door closed)
EV130 (door open)
