Renesas RX200 Series, User Manual

Page: 25 / 41

Renesas Solution Starter Kit for RX23W 6. Configuration
R20UT4446EG0102 Rev. 1.02 Page 25 of 41
Jun 22, 20
6.5 Clock Configuration
Table 6-5 below details the function of the option links associated with Clock Configuration.
Table 6-5: Clock Configuration Option Links
Reference Configuration Fit DNF Related Links
P47/CLKOUT_RF
Connect CLKOUT_RF to P36/EXTAL. R112, R89
R113, R108, R92,
R90, R97
X2
Connect CLKOUT_RF to MCU header. R113 R112 P47
XTAL1_RF, XTAL2_RF Connect 32MHz crystal (X1) to RX23W. - - -
XTAL, EXTAL
Connect 8MHz crystal (X2) to RX23W. R90, R97 R89, R96 -
Disconnect 8MHz crystal (X2) from RX23W and
connect to MCU header.
R89, R96, R108
R90, R97, R92 ,
R112
P36, P37
XCIN, XCOUT
Connect 32.768kHz crystal (X3) to RX23W.
R100, R99 R102 -
Disconnect X2 from RX23W.
R102 R100, R99 -
6.6 Analog Power and ADC Configuration
Table 6-6 below details the function of the option links associated with Analog Power and ADC Configuration.
Table 6-6: Analog Power and ADC Configuration Option Links
Signal name
MCU
MCU Peripheral Selection Destination Selection
Pin
Po
rt
Signal Fit DNF
Interface
/Function
Fit DNF
P07 C7 P07 SW1
R207 - SW1 - R206
P07 - - P07 - -
RV1-ADC C9 P40 RV1-ADC - -
RV1 - -
P40 - -
VREFH0 C10 - UC_VCC R121 - - - -
VREFL0 D10 - GROUND R124 - - - -
AVCC0-1 B10 -
UC_VCC R118 R127 or R128 - - -
Board_VCC R128 , R127 R118 - - -
AVSS0-1 A10 - GROUND R116 - - - -
6.7 CAN Configuration
Table 6-7 below details the function of the option links associated with CAN Configuration.
Table 6-7: CAN Configuration Option Links
Signal name
MCU MCU Peripheral Selection Destination Selection
Pin
Po
rt
Signal Fit DNF
Interface
/Function
Fit DNF
CAN0RX C2 P15 CAN0RX - -
U9.3 - -
P15 - -
CAN0TX C1 P14 CAN0TX - -
U7.3 - -
P14 - -