R0E521000CPE00 User’s Manual
5. Troubleshooting
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 84 of 92
5. Troubleshooting
This chapter describes how to troubleshoot when this product does not work properly.
5.1 Flowchart to Remedy the Troubles
Figure 5.1 shows the flowchart to remedy the troubles from when power to the emulator is activated until the emulator
debugger starts up. Check this while the user system is disconnected. For the latest FAQs visit the Renesas Tools Homepage.
http://www.renesas.com/tools
Turning on emulator
Upper panel LED
of emulator
Check the connection of power supply cable
.
See
“
2. 5 Connecting the Power Supply of the Emulator
”
( page 30)
Init dialog box of emulator
debugger displayed
1. Check the operating environment etc. of the emulator debugger.
See the user
’
s manual (online manual) of the emulator debugger.
2. Reinstall the emulator debugger.
MCU Setting dialog box of
emulator debugger
See 5.2. 2 MCU Setting Dialog Box Does Not Appear at
Emulator Debugger Startup
”
(page 85)
“
Connected
”
of the Output
window displayed
See 5.2. 3 Errors Occur at Emulator Debugger Startup
( page 86).
Emulator debugger startup completed
Not normal
Not normal/Error displayed
Not normal/ Error displayed
Error displayed
Starting up the emulator debugger
Setting MCU dialog box
Not normal/ Error displayed
Check the lot no. displayed
on the Init dialog box
Check that the USB interface cable is connected and the USB
driver is installed properly.
Setting Init dialog box
Figure 5.1 Flowchart to remedy the troubles
