Renesas M30830T-RPD-E, User Manual

Page: 26 / 74

( 26 / 74 )
Table 3.1 Switch settings of the M30830T-RPD-E (1/4)
Signal Switch Setting Description
P87/X
CIN
P86/X
COUT
SW1
SW2
X
OUT
SW3
Connects pin P87/X
CIN
of the MCU to the target
system (uses pin P87/X
CIN
as port P87).
Connects the LPF circuit on the emulation pod
when using the PLL function.
In this setting, it is necessary to set the JP2 on the
M30830T-RPDM board.
Connects pin P87/X
CIN
of the MCU to the sub-clock
oscillator (32.768 kHz) on the emulation pod.
Connects pin P86/X
COUT
of the MCU to the target
system (uses pin P86/X
COUT
as X
COUT
).
Pin X
OUT
of the MCU is unconnected.
Connects pin X
OUT
of the MCU to the target system.
Connects pin P86/X
COUT
of the MCU to the target
system (uses pin P86/X
COUT
as port P86).
Set to this position when using the PLL function
too.
SW1
P87
XCIN
PLL
P87
SW1
P87
XCIN
PLL
P87
SW1
P87
XCIN
PLL
P87
SW2
P86
XCOUT
PLL
P86
SW2
P86
XCOUT
PLL
P86
SW3
XOUT
OPEN
SW3
XOUT
OPEN
Factory-setting
Factory-setting
Factory-setting