E2, IE850A
2. Connecting the Emulator and User System
R20UT4140EJ0300 Rev.3.00
Page 5 of 41
Oct.09.20
2.Connecting the Emulator and User System
2.1
Connector
To connect the emulator to a user system, a connector must be mounted on the system. The 14-pin connector
and 34-pin connector can be used for external tracing. Mount the 34-pin connector if you intend to use
external tracing. Table 2-1 shows the two types of connector and supported emulators.
Table 2-1 Connectors and Supported Emulators
Supported Emulator
E2
IE850A
Connector
14-pin connector
Connectable.
Not connectable.
34-pin connector
for external tracing
Connectable via a 34-pin to 14-pin
conversion adapter (however,
external tracing is not available).
Can be connected.
2.1.1
14-pin connector
Table 2-2 shows the recommended connectors for connection of the E2 emulator. When other components
are mounted around the connector, do not mount components with heights exceeding 10 mm within 5 mm of
the connector on the user system as shown in Figure 2-1.
When designing the user system that mounts the 14-pin connector, refer to this section in this manual and the
user’s manual for the target device.
Table 2-2 Recommended 14-pin Connectors
Type Number
Manufacturer
Specification
14-pin
connector
7614-6002
3M Japan Limited
14-pin straight type (Japan)
2514-6002
3M Limited
14-pin straight type (other countries)
12
11
13
14
9
10
7
8
5
6
3
4
1
2
5 mm
5 mm
5 mm
5 mm
Top View
Area where restriction applies to mounted components
(components must have heights no greater than 10 mm)
Figure 2-1 Area where Restriction Applies to Mounted Components
