E2 Lite
R20UT3240EJ0300 Rev.3.00
Page 14 of 36
May.15.20
1.5
Regulatory Compliance Notices
1.5.1
European Union regulatory notices
This product complies with the following EU Directives. (These directives are only valid in the European
Union.)
CE Certifications:
•
Electromagnetic Compatibility (EMC) Directive 2014/30/EU
EN 55032 Class A
WARNING:
This is a Class A product. This equipment can cause radio frequency noise when used in the
residential area. In such cases, the user/operator of the equipment may be required to take
appropriate countermeasures under his responsibility.
EN 55024
•
Information for traceability
•
Authorized representative & Manufacturer
Name: Renesas Electronics Corporation
Address: TOYOSU FORESIA, 3-2-24, Toyosu, Koto-ku, Tokyo 135-0061, Japan
•
Person responsible for placing on the market
Name: Renesas Electronics Europe GmbH
Address: Arcadiastrasse 10, 40472 Dusseldorf, Germany
•
Trademark and Type name
Trademark:
Renesas
Product name: E2 Lite
Type name:
RTE0T0002LKCE00000R
Environmental Compliance and Certifications:
•
Waste Electrical and Electronic Equipment (WEEE) Directive 2012/19/EU
1.5.2
United States regulatory notices
This product complies with the following EMC regulation. (This is only valid in the United States.)
FCC Certifications:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
