Renault EXPRESS 2021, Vehicle User Manual, Page: 121 / 302

starting the engine .....................................
(up to the end of the DU)
Stop & Start function..................................
(up to the end of the DU)
engine standby ..........................................
(up to the end of the DU)
Stop & Start ...............................................
(up to the end of the DU)
2.5
ENG_UD70437_2
Fonction Stop and Start (XJK - Renault)
Stop and Start function
STOP AND START
function (1/3)
For all vehicles:
The warning light

on the instru-
ment panel is lit when the engine is on
standby.
The vehicle equipment remain opera-
tional while the engine is stopped.
When the engine switches to standby,
the steering assistance may no longer
be operational.
In this case it becomes operational
again when the engine is no longer on
standby or the speed exceeds approxi-
mately 1 mph (1 km/h) (downhill, slope
etc.).
This system enables a reduced fuel
consumption and lower greenhouse
gas emissions.
The system is activated automatically
when the vehicle is started.
While driving, the system stops the
engine (standby) when the vehicle is
at a standstill (traffic jam, traffic lights,
etc).
Conditions for engine
standby
The vehicle has set off from where it
was parked;
For manual gearboxes
:
– the gearbox is in neutral;
and
– the vehicle speed is less than ap-
proximately 7 mph (3 km/h).
and
– the clutch pedal is released.
If warning light

flashes, this
means that the clutch pedal is not
sufficiently released.
Do not drive off when the
engine is on standby (warn-
ing light

is displayed
on the instrument panel).
The engine MUST be
stopped (not put in standby)
before leaving the vehicle.
➥
2.3.
If you get out of the vehicle, a beep
notifies you that the engine is on
standby and has not been switched
off.
If the engine stalls while the system
is in operation, pressing the clutch
pedal right down will start it again.