MANUAL GEARBOX
Repairing the gearbox
21
21-31
Apply a line of
Loctite 518
to the gasket face.
Engage 3
rd
gear.
Introduce the housing while guiding the control shaft
into 3
rd
gear, fit the locking spring and ball as the 5
th
gear shaft appears.
Press down the locking ball and finish fitting the
housing.
Remove tool
B. Vi. 1570
.
Tighten the peripheral bolt to a torque of
2.5 daNm
after rotating the primary shaft to ensure correct
alignment of the bearings.
Fit the reverse gear shaft (A).
On the secondary shaft:
Put three drops of
Loctite Frenbloc
on the splines of
the fixed gear and fit it using tool
B. Vi. 1175
.
On the primary shaft, fit:
– the support washer (top side gear side),
– the sprocket bush,
– the 5
th
idle gear fitted with its synchro ring,
– the 5
th
gear hub fitted with its spring.
19808
19807
19806