Programming your remote
Handheld Remote – Multi Channel
ANT
ON OFF
Setting
Reset
3.1
Use the left and right arrows on the remote to
move UP/DOWN between the 5 channel options
until you reach your desired channel – the top
of the remote will illuminate the chosen channel
number – select 1 channel
ONLY
(not all 5).
3.2
Once the chosen channel is selected you can
now connect the Glide-Aside motor to that channel.
3.3
Using a paperclip or small screwdriver press
and hold in the
SETTING
button on the base
of the motor for 3 seconds until the motor beeps
then release. Discovery Mode is now activated.
CONFIRM
BUTTON
CHANNEL
UP/DOWN
SELECTED
CHANNEL
INDICATOR
C L
3.4
Now press the
CONFIRM
button with
a paperclip on the inside of your Wall switch.
The motor will beep 4 times to confirm pairing.
3.5
Now follow steps
2.2
to
2.6
to set your limits.
Press & hold for
3 seconds
then release
The motor will make
long beeps with a gap
This means discovery
mode is
activated
*
Continue to
Press & Hold for
7 seconds
Motor will beep quickly
8 times then go silent
All limit settings have
now been DELETED.
NOTE:
The programming/setup process for the Multi Channel remote is the same as that for
the Single Channel remote – the only difference being you need to select the specific channel you
want to operate your chosen Glide-Aside track first.
* Discovery Mode remains active and motor will continue to beep for 25 seconds ONLY. If you run out of time, simply repeat the process again.
The selected channel No. will
illuminate at top of remote.
With all 5 illuminated remote
will operate all channels at once
Base of
the Motor
REN073-2020NEW-06_v1
Tel
0113 250 4499
• Visit
rca-uk.com
