RENA Address Printer
612s(Ei1)_Operations Rev: 5/12/03
21
5.8 Setting the address print position
Before setting your desired address position, you must know which areas
the printer can reach.
The address height is positioned by shifting the print unit. The printable area
results from the neces sary margins and the offset path of the print unit:
Unprintable area
1
Print area
Offset area of
print unit
The upper margin of 15 mm shown here can be reduced to 0 mm if
required. To do this, shift the rear contact bracket onto the red mark. You
can now print without margins.
1
Maximum print width depends on width of piece and version of Flashware installed.
X+Y = 2 mm (0.078) with Flashware V9.xx or
↑
X+Y = 56 mm (2.205) with Flashware V5.xx or
↓
38 (1.5)
15 (0.6)
145 (5.7)
15 mm
(0.6
inch
)
