For Inclusion of Z-Wave devices into the remote controls network do the following steps: Press and hold the
left + right arrow keys simultaneously for 3 seconds and select "Add Device". Press the dedicated button on
the target device to include it.
If current primary controller in your network is in special SIS mode this and any other secondary controller can also
include and exclude devices.
To become primary a contoller have to be resetted and then include a device.
Exclude device from network
The primary controller can exclude devices from the Z-Wave network. During exclusion the relationship
between the device and the network of this controller is terminated. No communication between the device
and other devices still in the network can happen after a successful exclusion. The controller needs to be
turned into the exclusion mode. Once in this exclusion mode the other device needs to confirm the
exclusion - typically by pressing a button.
Attention: Removing a device from the network means that it is turned back into factory default status. This
process can also exclude devices from it's previous network.
For Exclusion of Z-Wave devices from the remote controls network do the following steps: Press and hold
the left + right arrow keys simultaneously for 3 seconds and select "Delete Device". Press the dedicated
button on the target device to exclude it.
Shift Primary Role to a different Controller
The device can hand over its primary role to another controller and become secondary controller.
Place the two controllers close to each other.
Bring your primary controller in the dedicated mode for primary shift (or learning mode).
Press and hold the up + down arrow keys simultaneously for 3 seconds.
Select "Create Pri."
There is also the posibilty to make your ZRC-100 to a primary controller.
Replicating All Network and Device Information from a Primary Controller to your ZRC-100:
Place the two controllers close to each other.
Bring your primary controller in the dedicated mode for primary shift.
Press and hold the up + down arrow keys simultaneously for 3 seconds.
Select "Learning Mode".
LCD display OK if the learning mode is successful. LCD display ERROR if the learning mode is
unsuccessful.
Set association between two device in Z-Wave network
(c) 2012 Z-Wave Europe GmbH, Goldbachstr. 13, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 6
