http://www.remotecontrol-express.com
Receiver-based programming:
1.
Open the casing of your receiver.
2.
Press both buttons P1 and P2 on y
down. The LED light on your new remote control blinks. Let the buttons go.
3.
On the receiver circuit board, press the programming button (SW1).
receiver blinks. Let the button go.
4.
While the LED light on your new remote control blinks, press a button on your new remote
control. Keep it pressed down. The LED light on the receiver stays lit constantly and then
goes out.
5.
Let the buttons go.
6.
Wait 10 seconds.
7.
Your new remote control is progra
Programming Manual
express.com
-
TEL :
+44 (0) 207 399 7782 - FAX :
+44 (0) 207 927
Open the casing of your receiver. It is located next to your motor.
Press both buttons P1 and P2 on your new remote control (figure 2). Keep them pressed
down. The LED light on your new remote control blinks. Let the buttons go.
On the receiver circuit board, press the programming button (SW1). The LED light on the
receiver blinks. Let the button go.
the LED light on your new remote control blinks, press a button on your new remote
control. Keep it pressed down. The LED light on the receiver stays lit constantly and then
Your new remote control is programmed.
+44 (0) 207 927 3151
our new remote control (figure 2). Keep them pressed
down. The LED light on your new remote control blinks. Let the buttons go.
The LED light on the
the LED light on your new remote control blinks, press a button on your new remote
control. Keep it pressed down. The LED light on the receiver stays lit constantly and then
