http://www.remotecontrol-express.com
FAAC TX2 SLH
Remarks:
-
In this line of remote controls, there are "master"
controls.
-
Only "master" remote controls can transmit their programming codes to other remote
controls.
-
To recognize them, press a button
-
If the LED light blinks once and then remains lit
control
-
If the LED light remains lit
-
Remote Control Express only se
-
The coding process will incite the opening of your garage door. To avoid an accident, we
recommend that you program your remote control while inside your garage.
Programming of your new remote control
There are several methods for programming your new remote control.
Remote-to-remote programming
ATTENTION :
During the coding process, if you press one of the buttons o
first, you run the risk of erasing the codes of all of the remote controls that have al
programmed
1.
Place an already-programmed remote control next to the new remote control so they touch
as shown in fig 1.
2.
Press the buttons P1 and P2 from your already
time (fig 2). Keep them pressed do
the buttons go.
3.
Press a button on your old
4.
While keeping the button
new remote control. Keep them pressed down.
5.
The LED light on your new remote control blinks twice.
6.
Let the buttons go.
7.
Wait 10 seconds.
8.
Your new remote control is programmed.
Programming Manual
express.com
-
TEL :
+44 (0) 207 399 7782 - FAX :
+44 (0) 207 927
TX2 SLH - TX4 SLH - TML4 SLH
te controls, there are "master" remote controls and "slave" remote
Only "master" remote controls can transmit their programming codes to other remote
To recognize them, press a button and keep it pressed down:
If the LED light blinks once and then remains lit constantly, it is a “master” remote
If the LED light remains lit constantly, it is a “slave” remote control
Express only sells “master” remote controls
The coding process will incite the opening of your garage door. To avoid an accident, we
recommend that you program your remote control while inside your garage.
ming of your new remote control:
for programming your new remote control.
remote programming:
During the coding process, if you press one of the buttons on the new remote control
first, you run the risk of erasing the codes of all of the remote controls that have al
programmed remote control next to the new remote control so they touch
Press the buttons P1 and P2 from your already-programmed remote control
(fig 2). Keep them pressed down. The LED light on your old remote control blinks. Let
old remote control.
While keeping the button on your old remote pressed down, press the same button
new remote control. Keep them pressed down.
your new remote control blinks twice.
Your new remote control is programmed.
+44 (0) 207 927 3151
remote controls and "slave" remote
Only "master" remote controls can transmit their programming codes to other remote
, it is a “master” remote
The coding process will incite the opening of your garage door. To avoid an accident, we
recommend that you program your remote control while inside your garage.
the new remote control
first, you run the risk of erasing the codes of all of the remote controls that have already been
programmed remote control next to the new remote control so they touch
programmed remote control at the same
remote control blinks. Let
pressed down, press the same button on your
